• Setting the [STANDBY] and [OFF TIME] for the print heaters. *Indicates available only during printing.

Timers can be programmed to place the printer heaters in STANDBY or OFF mode after printing. 『STANDBY』 sets the heater temperature to a preheat condition that is 3 to 5 degrees lower than the print heat. This prevents excess heat absorption by the print media. 『OFF TIME』 will switch off power to the heaters completely.
The heaters will perform as described in the table below:

※ The heaters will climb to the programmed temperature if any key is pressed or print data is received.

---

---

【1】 Confirm the setting of Priority of heater temperature: HOST or PANEL.
【2】 Set the below setting with priority.

●When heater temperature priority is 「PANEL」:
The heater control temperature will be set according to the printers programmed values.

●When heater temperature priority is「HOST」:
The heater control temperature will be set according to the values set in Raster Link Pro.
Set the heater settings on the [Print Condition] tab of Raster Link Pro.

---

---